|
|
Air Conditioners | Dehumidifiers | Dishwashers | Disposals | Dryers | Freezers | Humidifiers | Ice Makers | Microwave Ovens | Ovens, Ranges, Stoves | Refrigerators | Trash Compactors | Washers | Water Filters |
|
FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com
|
|
| Moderated by: RegUS_PatOff, BrntToast, appl.tech.29501 | Search Our Sites for More Info! |
|
|||||||||||||
| Tub Seal Repair? | Rating: 
|
| Author | Post |
|---|
| Posted: Wed Mar 8th, 2006 08:18 pm |
|
1st Post |
|
porschefan Senior Apprentice Appliantologist
|
I have a Maytag Neptune, model MAH5500BWW that has a slight leak from the tub seal. My question is, can I just seal the crack w/ something or should I really replace the entire tub seal to fix this? The crack in the seal is maybe a quarter inch long at the most. If I can seal it, is there anything anyone would recommend as far as sealants go? Can I just apply some silicone sealant and be done w/ it?
____________________ Appliance Moron Extremely thankful member of the forums. |
||||||||||||||
| |||||||||||||||
| Posted: Thu Mar 9th, 2006 11:44 am |
|
2nd Post |
|
Samurai Appliance Repair Man Fermented Grand Master of Appliantology 
|
Are you referring to the gray rubber boot between the door and the drum? If so, the only good, reliable repair I know of is to replace the boot. http://www.repairclinic.com/referral.asp?R=154&N=1063700
____________________ To ask a question, use our new forums==> http://appliantology.org 365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed! |
|||||||||||||
| ||||||||||||||
| Posted: Thu Mar 9th, 2006 03:55 pm |
|
3rd Post |
|
porschefan Senior Apprentice Appliantologist
|
Samurai Appliance Repair Man wrote:Are you referring to the gray rubber boot between the door and the drum? If so, the only good, reliable repair I know of is to replace the boot. Thanks for the reply, I expected that would be the answer. I guess I get to see how rusty my handyman skills are. Anything unusual about replacing the tub seal that I should know? Any specialized tools, etc? Chad P.S. Live Free or Die! P.P.S. I'm a Granite Stater as well, down near the MA border.
____________________ Appliance Moron Extremely thankful member of the forums. |
||||||||||||||
| |||||||||||||||
| Posted: Fri Mar 10th, 2006 03:43 am |
|
4th Post |
|
Samurai Appliance Repair Man Fermented Grand Master of Appliantology
|
Ahh, you're in for a treat. The attachment contains some excerpts from the manual that'll help you. Attachment: neptune_boot_replacement.zip (Downloaded 154 times)
____________________ To ask a question, use our new forums==> http://appliantology.org 365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed! |
|||||||||||||
| ||||||||||||||
| Posted: Fri Mar 10th, 2006 12:54 pm |
|
5th Post |
|
porschefan Senior Apprentice Appliantologist
|
Samurai Appliance Repair Man wrote:Ahh, you're in for a treat. The attachment contains some excerpts from the manual that'll help you. You know, when someone who does this for a living tells a rank amatuer like me "Ahh, you're in for a treat" that doesn't bode well. I'm someone who knows his limitations. In your professional opinion is this something that should be attempted by a novice or should I get a pro in to handle the replacement? If a pro, any recommendations in the Plaistow/Salem area?
____________________ Appliance Moron Extremely thankful member of the forums. |
||||||||||||||
| |||||||||||||||
| Posted: Fri Mar 10th, 2006 02:13 pm |
|
6th Post |
|
Samurai Appliance Repair Man Fermented Grand Master of Appliantology
|
If you have two hands and ten fingers and you don't have limp wrists or wet your bed, then you can do this repair.
____________________ To ask a question, use our new forums==> http://appliantology.org 365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed! |
|||||||||||||
| ||||||||||||||
| Posted: Wed Mar 15th, 2006 10:19 pm |
|
7th Post |
|
porschefan Senior Apprentice Appliantologist
|
Samurai Appliance Repair Man wrote:If you have two hands and ten fingers and you don't have limp wrists or wet your bed, then you can do this repair. Hmm... I meet all the criteria except wetting the bed. :laffinatchoo: Guess I'll give it a shot.
____________________ Appliance Moron Extremely thankful member of the forums. |
||||||||||||||
| |||||||||||||||
| Posted: Thu Mar 30th, 2006 08:18 pm |
|
8th Post |
|
porschefan Senior Apprentice Appliantologist
|
Finally got a chance to work on the washer and the job was easier than I expected. The only difficult part was getting the spring strechted out and hooked to the other end of the retaining wire without pulling the seal out of place. Ran a load of laundry through it and it seems to be working fine, no leaks I can find. Thanks SAR, without this site and your feedback I wouldn't have attempted this myself.
____________________ Appliance Moron Extremely thankful member of the forums. |
|||||||||||||
| ||||||||||||||
| Posted: Thu Mar 30th, 2006 08:29 pm |
|
9th Post |
|
Samurai Appliance Repair Man Fermented Grand Master of Appliantology
|
Way to go, Buddy-row! Congrats on the repair.  Did you happen to take pictures of your wrestling match with the beast?
____________________ To ask a question, use our new forums==> http://appliantology.org 365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed! |
||||||||||||||
| |||||||||||||||
| Posted: Fri Mar 31st, 2006 06:52 am |
|
10th Post |
|
Mad Mac Fellow, Academy of Sublime Masters of Appliantology 
|
Samurai Appliance Repair Man wrote:If you have two hands and ten fingers Now that the repair is complete, I recommend that you re-visit this question.
____________________ Mad Mac....Pray to God he's out there....somewhere. |
|||||||||||||
| ||||||||||||||
| Posted: Fri Mar 31st, 2006 11:10 pm |
|
11th Post |
|
porschefan Senior Apprentice Appliantologist
|
Unfortunately no pictures, didn't have the digicam handy while I was doing the repair. Thanks again though for the guidance and the encouragement.
____________________ Appliance Moron Extremely thankful member of the forums. |
||||||||||||||
| |||||||||||||||
Current time is 03:29 pm
|
|
| ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Laundry Appliance Repair Forum > Tub Seal Repair? | Top |
| Find Appliance Parts & Diagrams Here |
| Enter a model number, part number, type of appliance, brand, or even a part description. |
|
365-day return policy on all parts ordered through this site! |
FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com
