ApplianceGuru.com:  The Samurai Appliance Repair Forums Home


Air Conditioners | Dehumidifiers | Dishwashers | Disposals | Dryers | Freezers | Humidifiers | Ice Makers | Microwave Ovens | Ovens, Ranges, Stoves | Refrigerators | Trash Compactors | Washers | Water Filters

FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com

Find Appliance Parts & Diagrams Here
Enter a model number, part number, type of appliance, brand, or even a part description.

365-day return policy on all parts ordered through this site!


 Moderated by: RegUS_PatOff, dkpd1581, applianceman18007260692 Search Our Sites for More Info!
New Topic Reply Printer Friendly
heating options  Rate Topic 
AuthorPost
 Posted: Thu Feb 9th, 2006 05:02 am
  PM Quote Reply
1st Post
Crouching Tiger

 

Joined: Sun Nov 13th, 2005
Location:  
Posts: 216
Flavorite Brew: 
Status: 
Offline
I'm looking to build a two storey house with full basement.  First and second floors are hoping to be 1000 sq. ft. each.  The location is southern Ontario which is warm and humid in the summer and usually fairly cold in the winter.  Natural gas is not available in the rural section of town.  My options are either propane, oil or electric.  I would like a forced air unit so that a C/A unit can be installed.  I will also be installing at least one propane fire place which will be on the main floor.  Should I consider radiant in floor heating as an option?  I am also going to look up info on heat pumps.  Any additional information would be a great help.

Back To Top PM Quote Reply  

 Posted: Thu Feb 9th, 2006 06:01 am
  PM Quote Reply
2nd Post
jahjahbinks



Joined: Sat Jun 25th, 2005
Location: USA
Posts: 271
Flavorite Brew: GREEN TEA
Status: 
Offline
 would suggest the heat pump for now but have you checked into solar heat? i`m cheep and will try to be as self reliant as posibile , what you need to look at is cost and need , well you need power to run whatever you have  if you can go solar go for it , then you have the windmill @3mph will supply more energy then you need , you can install these yourself , or get a generic power unit cost about $3.000.00 to 8.000.00 and run it off propane however you will have to shut it down for general maintaince , all that a have suggested i have used and found to work fine , self powered sence 2001 ,  but have still have all gas and electric appliances ready to operate. even my engineering teacher was impressed . just do some FOWARD THINKING.



____________________
outerspace holds the key to the biggest mystery in the universe . where do women come from ?
Currently serving SPEED QUEEN , HUEBSCH
Back To Top PM Quote Reply

 Posted: Sat Feb 11th, 2006 05:12 pm
  PM Quote Reply
3rd Post
ServiceGuy
Senior Apprentice Appliantologist
 

Joined: Sat Feb 11th, 2006
Location:  
Posts: 6
Flavorite Brew: 
Status: 
Offline
Interesting Topic, Solar power.

Any links for more info on wind mills?

Heatpumps are fairly useless below 40F

You'll then have to have either electric strip or propane for comfort on those degree days below 40.

If the price is right, radiant floor heat is a major winner. That would be the direction I would go. I think the only consideration would be the cost of propane. Find out and tell us about it!!  

Good luck

Bernie  

Back To Top PM Quote Reply  

 Posted: Tue May 23rd, 2006 10:53 pm
  PM Quote Reply
4th Post
Northern-Tech
Master Appliantologist
 

Joined: Wed May 17th, 2006
Location: White River, Ontario Canada
Posts: 74
Flavorite Brew: 
Status: 
Offline
I realize that you are looking for something, that central air can be tied into. Just for info, last year, I put in an outdoor woodstove, from Central boiler. This heats 2 houses, with approx 4500 sq. feet. The houses have never been warmer, and yes,. it gets cold up here. ( At one time, White River was famous for the big thermometer on the highway, that said, the coldest spot in canada ). Im sure it wasn't, but it does get cold. I dont know if this is an option for you,....... availablilty off wood, local bylaws,etc. ( some places will not allow them in areas, due to possibility of smoke bothering your neighbour ). Was not an issue for me. If you need further info, let me know and I will be glad to assist.                                 ;)

Back To Top PM Quote Reply

 Posted: Wed May 24th, 2006 04:29 am
  PM Quote Reply
5th Post
Crouching Tiger

 

Joined: Sun Nov 13th, 2005
Location:  
Posts: 216
Flavorite Brew: 
Status: 
Offline
Thanks for the input.  I know what you mean about cold - I lived in Timmins for two years - the skiing was great but I remember some days coming down the hill with a   -35 'C wind in my face freezing the tears in my eyes instantly. 

Since my last post I have done some good research as to which fuel I will be considering.  I plan on buying a gas dryer, range and fireplace and water heater as well as having the BBQ with a quick disconnect outside eliminating the chance of running out of fuel two minutes into grilling a nice juicy sirloin.  These will all be on propane, so I might as well go for the high efficiency propane furnace as well.  I am also installing a heat pump that is able to guarantee a good heat supply down to -5'C which will also provide cooling in the summer.  Of course I am going to have to have the cigar tank sitting outside to handle the load but I have no choice about that. 

I have talked with others in the area who have the Central boiler system and they have a hard time keeping the supply of wood around.  The average price for a cord of wood cut , delivered, and stacked is about $250 Cdn.  The acreage we are building on is mainly farm fields so cutting the wood myself is not an option, besides I don't much like the thought of having to cut, split and store wood - I'd rather stick pine needles in my eyes.

The only thing I have to do now is find a good supplier of propane that will give us a good price plan. 

Back To Top PM Quote Reply  

 Posted: Fri May 26th, 2006 03:59 am
  PM Quote Reply
6th Post
applianceman18007260692
Fellow, Academy of Sublime Masters of Appliantology


Joined: Thu Nov 17th, 2005
Location: Mobile, Alabama USA
Posts: 1119
Flavorite Brew: Keystone Light
Status: 
Offline
why not use as an alternative ? a chem/hydro/solar dome? this dome has thousands of mirrors focused on a ceramic boiler which is thermally induced by evaporation propertys in the chemically treated water which is then transferred to base boards that sense chemical reactions to heat and cold.



____________________
"May the hinges of our friendship never grow rusty"
-old Irish saying

Buy me a Beer: http://web.me.com/zenzoidman/applianceman18007260692/
Back To Top PM Quote Reply

 Posted: Mon May 29th, 2006 03:01 am
  PM Quote Reply
7th Post
Crouching Tiger

 

Joined: Sun Nov 13th, 2005
Location:  
Posts: 216
Flavorite Brew: 
Status: 
Offline
Thanks for the reply, although this would address my heating supply I am still going to have the propane outside to fire the range, dryer, fireplace and maybe a unit heater for the garage. 

Back To Top PM Quote Reply  

You have chosen to ignore ahammer48. click Here to view this post

Current time is 09:17 am Tell a friend about this page... all your other friends are doing it!  
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > Heating, Ventilation, and Air Conditioning (HVAC) > heating options Top



Find Appliance Parts & Diagrams Here
Enter a model number, part number, type of appliance, brand, or even a part description.

365-day return policy on all parts ordered through this site!

FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com

Your Sometimes-Lucid Host:
ApplianceGuru.com:  The Samurai Appliance Repair Forums Home
"If I can't help you fix your appliance and make you 100% satisfied, I will come to your home and slice open my belly, spilling my steaming entrails onto your floor."


UltraBB 1.17 Copyright © 2007-2008 Data 1 Systems
Page processed in 0.4336 seconds (13% database + 87% PHP). 28 queries executed.

Web Analytics