|
|
Air Conditioners | Dehumidifiers | Dishwashers | Disposals | Dryers | Freezers | Humidifiers | Ice Makers | Microwave Ovens | Ovens, Ranges, Stoves | Refrigerators | Trash Compactors | Washers | Water Filters |
|
FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com
|
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Laundry Appliance Repair Forum > fisher and paykel mw051-u |
|
| Moderated by: RegUS_PatOff, BrntToast, appl.tech.29501 | Search Our Sites for More Info! |
|
|||||||||||||
| fisher and paykel mw051-u | Rate Topic |
| Author | Post |
|---|
| Posted: Sun Oct 3rd, 2010 03:14 am |
|
1st Post |
|
fidget Grasshopper
|
The washing machine fills ok and then starts the wash cycle. agitator will spin a few times, do a brief little back and forth, then maybe even agitate ok for a while more before it stops and machine goes beep. powering off and on again results in a repeat of the above. spin cycle works ok. tried the diagnostic (hold temp down and press power and then advance, press spin three times to get hold and slow spin lights on) found on previous posts in this forum and get the first and second last lights of progress lights on. i haven't managed to find the diagnosis interpretation stuff, could someone tell me what this means please? thankyou
|
||||||||||||||
| |||||||||||||||
| Posted: Sun Oct 3rd, 2010 04:28 am |
|
2nd Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology 
|
fidget wrote: .. the first and second last lights of progress lights on. .. x00000x0 130. Single Rotor Position Sensor Error The Motor Control Module has found an error in the pattern received from the Rotor Position Sensor. Likely causes of this fault are a bad connection on the harness between the Rotor Position Sensor and the Motor Control Module, or a faulty Rotor Position Sensor. Primary Source: Wiring. Action: 1. Check for corrosion on the edge connector of the Rotor Position Sensor and the Motor Control Module connector. 2. Check the contacts on the rotor positional sensor end of the hall harness to see if any have been damaged. (Each set of contacts in the socket has two wipers. If the distance between these wipers varies between different contacts, replace the rotor positional sensor harness.) Secondary Source: Rotor Position Sensor. Action: Check the Rotor Position Sensor with an R.P.S. tester. Replace if faulty. Tertiary Source: Motor Control Module. Action: Replace Motor Control Module.
____________________ The new repair forums==> http://appliantology.org RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA |
|||||||||||||
| ||||||||||||||
| Posted: Sun Oct 3rd, 2010 04:48 am |
|
3rd Post |
|
Samurai Appliance Repair Man Fermented Grand Master of Appliantology 
|
Good stuff, Reg!
____________________ To ask a question, use our new forums==> http://appliantology.org 365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed! |
||||||||||||||
| |||||||||||||||
| Posted: Tue Oct 5th, 2010 03:20 am |
|
4th Post |
|
fidget Grasshopper
|
Thankyou. I'll check this out. You folks rock!!
|
|||||||||||||
| ||||||||||||||
| Posted: Fri Oct 15th, 2010 04:02 am |
|
5th Post |
|
fidget Grasshopper
|
Could you be so kind to direct me to/supply a manual for this? Fisher & Paykel smartdrive 051, model MW051-U. top load.
|
||||||||||||||
| |||||||||||||||
| Posted: Fri Oct 15th, 2010 04:13 am |
|
6th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
For service manuals and lots of other goodies, become an Apprentice==> http://apprentice.applianceguru.com
____________________ The new repair forums==> http://appliantology.org RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA |
|||||||||||||
| ||||||||||||||
| Posted: Fri Oct 15th, 2010 04:43 am |
|
7th Post |
|
fidget Grasshopper
|
Is there an alternative to paypal? Online deposit or some such?
|
||||||||||||||
| |||||||||||||||
| Posted: Thu Oct 21st, 2010 01:30 am |
|
8th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
links PM'd
____________________ The new repair forums==> http://appliantology.org RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA |
|||||||||||||
| ||||||||||||||
Current time is 01:33 am
|
|
| ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Laundry Appliance Repair Forum > fisher and paykel mw051-u | Top |
| Find Appliance Parts & Diagrams Here |
| Enter a model number, part number, type of appliance, brand, or even a part description. |
|
365-day return policy on all parts ordered through this site! |
FAQs | Contact | Apprenticeship | Consultations | Parts | Model Number Help | Newsletter | Beer | Fixitnow.com
