jm56
Grasshopper
| Joined: | Mon Apr 4th, 2005 |
| Location: | |
| Posts: | 13 |
| Flavorite Brew: | |
| Status: |
Offline
|
|
Just got a hanging fan for my workshop: Reznor xl 170, current model number is f-165
I have read the manual available at rezspce.com. This is for the newest mondle with spark pilot.
I have an older version with gas pilot.
It also has a basic gas valve, only two wire connections: "ITT General Controls."
A wiring box is attached to the back of the fan motor housing, with a transformer attached to one end of the box.
Wires and connection:
black yellow red ::: attached to 2 sensors in the furnace, black connected to both
Tan white ::: motor
black white ::: transformer
screws 2 ::: transformer
screws 2 ::: gas valve
This is how I figger it should be wired:
The 2 transformer screws, through a thermostat (in series , one side), to the gas valve's 2 screws
AC
black :: connect to: black to the sensors
white :: connect to: white motor and white transformer
sensors (I am assuming the larger black sensor is the fan control switch)
black (hot) :: connect to: AC black
yellow (sensor: heat limit) :: connect to: white transformer
red (sensor: fan control) :: connect to: tan motor
Am I correct?
Jesse
|
