- Home


Air Conditioners | Dehumidifiers | Dishwashers | Disposals | Dryers | Freezers | Humidifiers | Ice Makers | Microwave Ovens | Ovens, Ranges, Stoves | Refrigerators | Trash Compactors | Washers | Water Filters

FAQs | Contact | Apprenticeship | Parts | Model Number Help | Newsletter | Beer
- > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher & Paykel DD602 -- upper drawer has no power

Find Appliance Parts & Diagrams Here
Enter a model number, part number, type of appliance, brand, or even a part description.

365-day return policy on all parts ordered through this site!


 Moderated by: BrntToast, RegUS_PatOff, appl.tech.29501 Search Our Sites for More Info!
New Topic Reply Printer Friendly
Fisher & Paykel DD602 -- upper drawer has no power  Rate Topic 
AuthorPost
 Posted: Fri Jun 24th, 2005 12:37 am
  PM Quote Reply
1st Post
appliance anjinsan
Grasshopper
 

Joined: Tue Apr 19th, 2005
Location:  
Posts: 3
Flavorite Brew: 
Status: 
Offline
A rodent ate through the water supply to my upper DD. While awaiting the replacement hose, I plugged the old hose and unplugged the wires going to the valve that diverts water to the upper DD. 
 
 I finally received the replacement hose and replaced it.  Installation seemed to go fine.  Had to remove the front cover (I did remember to reconnect the ground wire on the cover) to do so.  Reinstalled, plugged the connecter back into the diverter valve.  Reset the circuit breaker.  No workee.  I get no power indication at the display at all.
 
Lower unit continues to work fine.  When I switch the breaker on, the display turns green, there's an audible beep, etc., on the lower unit.  But nothing on the upper.  Zero.  Zilch.
 
Is there something obvious I've overlooked?  Do you have any suggestions for troubleshooting to narrow down the location of the problem?
 
Thanks,
 
Anjinsan

Back To Top PM Quote Reply  

 Posted: Fri Jun 24th, 2005 08:04 am
  PM Quote Reply
2nd Post
Samurai Appliance Repair Man
Fermented Grand Master of Appliantology


Joined: Mon Mar 21st, 2005
Location: Otterville, New Hampshire USA
Posts: 16082
Flavorite Brew: Kirin Ichiban
Status: 
Offline
Sounds like one of the wire harness connectors on the control board isn't snapped in all the way.  Disconnect and reconnect 'em all.


Fisher Paykel DD602 dishdrawer with the front panel removed.


Check for 120v supply going into the the main control board.

Last edited on Fri Jun 24th, 2005 11:52 am by Samurai Appliance Repair Man



____________________
To ask a question, use our new forums==> http://appliantology.org

365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed!
Back To Top PM Quote Reply

 Posted: Fri Jun 24th, 2005 09:08 am
  PM Quote Reply
3rd Post
Kiwi-nadian



Joined: Tue May 24th, 2005
Location: Cowtown, Alberta Canada
Posts: 376
Flavorite Brew: DB Export Gold (NZ)
Status: 
Offline
Also check the wiring loom to the top drawer from the mains board up, as the mouse may have had a go at this when he did the water hose (:shock:seen it a hundred times...................). 



____________________
please help us to help you, http://www.fixitnow.com/beerfund.htm
Back To Top PM Quote Reply  

 Posted: Mon Jul 4th, 2005 03:28 pm
  PM Quote Reply
4th Post
appliance anjinsan
Grasshopper
 

Joined: Tue Apr 19th, 2005
Location:  
Posts: 3
Flavorite Brew: 
Status: 
Offline
I have disconnected and reconnected all of the connections.  Also checked the wiring harness to make sure the rodent hadn't chewed threw it.  Still no power to the unit.
 
You mentioned checking the 120 volt to the main control board.  Are you talking about the board on the bottom of the lower unit, or are you referring to the control board behind the front panel?  In either case, is there an "obvious" spot to check it?
 
Thanks,
 
Anjinsan

Back To Top PM Quote Reply

 Posted: Mon Jul 4th, 2005 06:36 pm
  PM Quote Reply
5th Post
Samurai Appliance Repair Man
Fermented Grand Master of Appliantology


Joined: Mon Mar 21st, 2005
Location: Otterville, New Hampshire USA
Posts: 16082
Flavorite Brew: Kirin Ichiban
Status: 
Offline
Click the photo in my previous post for the larger view.  You'll see three wire harness connectors along the bottom of the control board.  One of them supplies line voltage.  Gaze lovingly upon the inscriptions just above the wire harness connectors (on your own dishdrawer) and the line voltage location shall be revealed unto thee.  Cro Maat.



____________________
To ask a question, use our new forums==> http://appliantology.org

365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed!
Back To Top PM Quote Reply  

 Posted: Thu May 24th, 2007 11:52 pm
  PM Quote Reply
6th Post
GJS
Senior Apprentice Appliantologist
 

Joined: Tue May 22nd, 2007
Location: Australia
Posts: 5
Flavorite Brew: Cascade Premium
Status: 
Offline
I had a similar problem with my lower drawer, completely dead. Found that the solder fuse in the heating element had blown. For some reason this causes the whole unit to power down

Back To Top PM Quote Reply

Current time is 10:04 am Tell a friend about this page... all your other friends are doing it!  
- > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher & Paykel DD602 -- upper drawer has no power Top



Find Appliance Parts & Diagrams Here
Enter a model number, part number, type of appliance, brand, or even a part description.

365-day return policy on all parts ordered through this site!

FAQs | Contact | Apprenticeship | Parts | Model Number Help | Newsletter | Beer

Your Sometimes-Lucid Host:
- Home
"If I can't help you fix your appliance and make you 100% satisfied, I will come to your home and slice open my belly, spilling my steaming entrails onto your floor."


UltraBB 1.17 Copyright © 2007-2008 Data 1 Systems
Page processed in 0.1138 seconds (32% database + 68% PHP). 26 queries executed.

Web Analytics