| View single post by Trying to help | |||||||||||||
| Posted: Fri May 30th, 2008 11:14 am |
|
||||||||||||
Trying to help
|
The clean light flashing with another light is an indication of a failure sensed by the board. You will want to access the wiring schematic under the kick plate and take a look at what it is indicating. You can then put the board into an auto diagnostics to see what it comes up with. I believe the fault code is for low or high current sensed. You will need a volt/ohm meter to ohm out the motor windings. If that is what the code is for, your start windings (wash and drain) are about 7 ohms each and your main winding 3.
____________________ If we saved YOU Beer $$ today, please make a donation to our beer fund by clicking the link below to help keep this site going. I charge $135.95 PLUS PARTS to do this repair!$! http://fixitnow.com/beerfund.htm |
||||||||||||
|
| |||||||||||||
