View single post by sejarzo
 Posted: Sat Apr 26th, 2008 11:18 am
PM Quote Reply Full Topic
sejarzo

 

Joined: Fri Apr 25th, 2008
Location:  
Posts: 6
Status: 
Offline
 Anybody know what causes the water flow to stop during the cold and hot fill steps in the diagnostic cycle?

When the diagnostic cycle ran fine, I didn't see a huge amount of water in the tub.

After letting it sit overnight, I'm back to getting the FH error code during the C:03 step, twice in a row. The hot water flowed for a longer time than it did during a successful cycle, and there is definitely more water visible in the tub than in a successful cycle.

So after possibly(?) unsticking the flowmeter last night, the diag cycles have always made it through C:01....so the flowmeter appears to work consistently at that point.

Does the hot water flow continue in C:03 until the pressure switch closes to indicate a normal water level, and if the pressure switch does not make in a set amount of time, it stops and displays the FH code?

Or....does the hot inlet valve open, and if the flowmeter does not totalize the proper amount of water within a given amount of time, or does not totalize the proper amount of water before the pressure switch makes to indicate a normal level in the tub, the flow stops and the FH code is displayed?

Last edited on Sat Apr 26th, 2008 12:22 pm by sejarzo