View single post by Snappy

Posted: Sun Nov 25th, 2007 02:56 pm

Quote

Full Topic

Snappy

Joined:	Sun Nov 25th, 2007
Location:	USA
Posts:	14
Status:	Offline

Thanks. I have done as instructed. The motor did not start. I am unable to test the voltage at the board where the black and white wires connect as I have to get my multimeter back from the friend I lent it to.

As I understand it, if there is 120VAC at the control board, the motor is bad. If there is not 120VAC at the board, am I to assume that the board is bad, or are there more diagnostics? Also if the board is bad, what is the part number for it?

Thanks again.