View single post by Snappy
 Posted: Sun Nov 25th, 2007 03:09 pm
PM Quote Reply Full Topic
Snappy



Joined: Sun Nov 25th, 2007
Location: USA
Posts: 14
Status: 
Offline
I have a Maytag MAH3000AWW that was purchased in 1998.  Apart from the mold issue (long since fixed by Maytag), the unit has worked like a charm.  Unitl Now.....

No matter what part of the cycle I start the unit in, it will run for 20-40 seconds, then sit idle for another 30-60 second and turn itself off.  I have visually inspected the control board and no resistors are blown, including the infamous R11.  The unit fills with water and drains fine, but the drum does not turn in any part of the cycle.

Any advice on where to go next?

Last edited on Sun Nov 25th, 2007 03:10 pm by Snappy