View single post by Samurai Appliance Repair Man
 Posted: Sun Jul 1st, 2007 09:21 am
PM Quote Reply Full Topic
Samurai Appliance Repair Man



Joined: Mon Mar 21st, 2005
Location: Otterville, New Hampshire USA
Posts: 16081
Status: 
Offline
 OK, the diagram I found is only slightly more detailed that the one you posted and equally unilluminating. However, I think it's highly unlikely that you could place the drain check balls in the well in an arrangement that would cause the Separator/Filter Assy to split. BTW, could you post a picture of that?

Also, the pump outlet has been a common troublemaker on this otherwise fine dishwasher. The common failure is that one of the seams splits allowing water to escape sideways rather than getting forced up into the spray arm. On a dishwasher of this vintage and with this problem, it's usually worth going ahead and replacing it to avoid a future failure.



____________________
To ask a question, use our new forums==> http://appliantology.org

365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed!