View single post by mnementh
 Posted: Sun Jul 1st, 2007 05:08 am
PM Quote Reply Full Topic
mnementh



Joined: Sat Jun 30th, 2007
Location: San Antonio, Texas USA
Posts: 10
Status: 
Offline
Wow! A personal response from the Samurai himself!

*Proffers an ice-cold Kirin, then bows deeply from the waist* *NAMASTE*

Thanks... Yes, the KA manual (Found here)

http://tinyurl.com/34h5nm

is very clear on how to place the single ball check you refer to... it goes as shown in the diagram above, in a pocket in the inlet base which is attached to the bottom of the Separator/Filter. But for some reason, it makes no reference at all to the correct placement of the drain check balls, instead concentrating on the motor shaft alignment procedure/seal replacement, then moving right on to chopper assemby with the drain cover shown already installed.:huh:

My model # is: KUDR24SEBL3 , though the only reference I've been able to find anywhere on the service of the actual pump assembly itself has been the above manual.

Thanks for the quick response,

Mnem
"Pizza is nature's way of controlling the anchovy population." :stooges:

Last edited on Sun Jul 1st, 2007 09:52 am by



____________________
"Mrs K, I'm afraid it's bad news. Your son was born with... THE KNACK."

"Isn't there anything we can do?"

"I'd say start with a socket set, and maybe a good multimeter..."