View single post by cncguy2000
 Posted: Thu Jun 14th, 2007 08:05 am
PM Quote Reply Full Topic
cncguy2000

 

Joined: Fri Nov 10th, 2006
Location:  
Posts: 5
Status: 
Offline
Well I have had my Staber for over 3 years now, only a couple problems. and one was our fault.

Unit was leaking water when spinning... after troubleshooting with Staber found the following... bad gasket on Plastic piece that sits on top of Stainless Hsg.

Washer would spin up and spray water around gasket onto floor.

other problem is our fault, you need to empty pockets, coins will slip between hatch and get sucked into pump.  Then you have to disconnect drain hose and remove said coinage.  The best way is to just tilt unit back and get it from underside.

It's a PITA to take the curved front cover off and get it back on.

Other than that, it's been a great washer, super skimpy on soap.

Has anyone  tried their dryers, I am moving soon and will need a gas dryer.

Thanks

-Henry