View single post by BrntToast
 Posted: Sat Mar 31st, 2007 01:13 pm
Full Topic
BrntToast



Joined: Wed Mar 14th, 2007
Location: Winnipeg, Manitoba Canada
Posts: 1088
Status: 
Offline
 before you buy a board for that washer i would check for crushed/cut wires at the SCU(the board at the back with the white case) look and make sure the plastic cover is clicked in securly cause it holds the small wiring harness in place and also check all wires running down the front of the board because the way frigidaire routed the wires if the tub goes out of balance enough the motor pinches the wires between the motor and the case for the SCU

free tip, save yourself the cut arm and run some tape along the edge of the opening in the back, i swear frigidaire has someone on the assembly line sharpening that edge with a wet stone



____________________
The only stupid question is the one not asked
hope i've been helpfull, if you wish to buy Brnt beer kick here

http://brnttoast.googlepages.com/home

feel free to prvt msg frigidaire questions my way
(i dont log in every day)