View single post by stonkers
 Posted: Tue Mar 27th, 2007 10:14 pm
Full Topic
stonkers

 

Joined: Tue Mar 27th, 2007
Location:  
Posts: 10
Status: 
Offline
OK, I ran the diagnostic tests.  All tests, including spin (it spins like the dickens in diagnostic mode) passed with flying colors.  When I hit the final test to get the error code, it revealed an E47, which is:

Board thinks the door PTC circuit is open in spin

Check says: Refer to test (9)

This test is the one to do the high spin test and check the door lock.  It spun and locked during that test.  Any help on where I go from here?

Thanks,
Eric

P.S. - As a sidenote, I wanted to look into what a board would cost, but your "Parts Detective" can't find my model which I am positive is:

Kenmore 417.44092500 (double checked with Sears Service)

Last edited on Wed Mar 28th, 2007 05:26 pm by stonkers