View single post by KurtiusInterupptus
 Posted: Fri Mar 2nd, 2007 08:50 pm
PM Quote Reply Full Topic
KurtiusInterupptus

 

Joined: Fri Jan 12th, 2007
Location: Hickory, North Carolina USA
Posts: 459
Status: 
Offline
I really recommend the test Crouching Tiger told you about. If you make yourself a jumper from a small gauge wire (18-24 Ga.), like thermostat wire, remove the emitter board ( right side) and unplug connector. Jump black and black/white wires through the same holes  that slides over the prongs on the board. Have your larger jumper between T and H on i/m module when you do this. Its really not as hard as it sounds. Speaking of the module, have you checked that the locking tabs on the white  motor gear, right in center of the wheel ,are unbroken? poke around w/ a small screwdriver, Gently. IF one of those tabs is loose or falls right out, you got yerself a bad module.

 



____________________
As every cockroach knows , thriving on poisons is the secret of success.