 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sun Jan 21st, 2007 |
| Location: | |
| Posts: | 6 |
| Status: |
Offline
|
The oven vents are right under the touchpad.......I tried the "hot" cancel then quick disconnect of the ribbon wire with these results: After powering up the range the F1 appears in appox. 30 seconds every time. Hitting "cancel" clears fault. With ribbon disconnected fan starts in 2 seconds and F1 returns after 5 seconds and now won't clear when "cancel" is pressed. Calling for an oven pre-heat to 400 deg. results in a normal indicated temp rise to an indicated 400 deg. with the fan starting at 220 deg. A switch can be heard cycling under the glass cook-top and when this happens the display is brighter for a second. Prior to the pre-heat test I disconnected the the orange and blue wire groups and systematically ohm tested the pins to try and get the 1090 ohm reading from the temp sensor at the ERC. No luck. The oven is holding 400 deg. for the last 25 minutes, with all other functions normal. Thanks for the responses I hope this info provides a clue.
PS: Apparently Grasshoppers should NOT think that they can reassemble a hot control panel without doing some welding on the side!