View single post by That Guy
 Posted: Thu Jan 18th, 2007 06:30 am
Full Topic
That Guy



Joined: Wed Jan 17th, 2007
Location: Nebraska USA
Posts: 226
Status: 
Offline
Don't lay it on its side and try and take the bottom off. The motor bolt comes out through the cover on the back and the front opens up so you can get to the motor control board and pull the motor out through the front opening.

To remove the front. Take out the four screws around the door (two on the left, two on the right), remove the door and then the "u" shaped front panel. It just pulls forward at the top and then is hinged at the bottom. You can see the motor control board on the lower left.

 Don't try and run the a new style board with an old motor or an old board with a new style motor. They are not compatible.