View single post by Samurai Appliance Repair Man

Posted: Sun Dec 10th, 2006 06:28 pm

Quote

Full Topic

Samurai Appliance Repair Man

Joined:	Mon Mar 21st, 2005
Location:	Otterville, New Hampshire USA
Posts:	16081
Status:	Offline

Start back at the water inlet valve in back. Identify the coil that serves the dispenser (follow the plastic tubing) and get your volt meter on it. Actuate the dispenser and see if you're getting 120vac at that valve coil. If so, and no water, then the valve is bad, replace it. http://www.repairclinic.com/referral.asp?R=154&P=69

If you're not getting voltage there, then there's a problem with the dispenser actuator or switch. Post your findings and we'll go from there.

____________________
To ask a question, use our new forums==> http://appliantology.org

365-Day No-Hassle Return Policy on all parts purchased through this site, even electrical parts that have been installed!