View single post by LindaP
 Posted: Mon Oct 16th, 2006 08:07 pm
Full Topic
LindaP

 

Joined: Mon Oct 16th, 2006
Location:  
Posts: 1
Status: 
Offline





My F/H error code was caused by a hole in the air line, causing the machine to overfill, stop, and beep. This was a simple repair with my "quick fix." Remove the top of the washer (three screws at the back). I purchased a plastic barb coupling, 3/16" x 3/16," at a hardware store, cut out about 2" of the  black rubber tubing which was flatted and worn thin to a hole, and spliced the two pieces with the coupling. Have the coupling at hand when you do this, don't drop the lower end of the tubing. Seat the coupling into the lower end and then attach it to the upper end. I used a nylon tie to secure the tubing to the broken retainer clip at the side of the case, end of problem. Cost was $1.11.

Last edited on Mon Oct 16th, 2006 08:42 pm by LindaP