View single post by klfirestine
 Posted: Thu Sep 28th, 2006 03:09 am
PM Quote Reply Full Topic
klfirestine

 

Joined: Wed Sep 27th, 2006
Location:  
Posts: 1
Status: 
Offline
Wow, we would have never figured this out without this tip, took me awhile but I finally figured out what you meant.  Note to others, the latch assembly (which is part of internal controls goes against the actuator (this is at the top of the diswasher that is built into your cabinet). Hope I didn't confuse things but it took me awhile to figure this out. Thanks, I saved around $160 for the Maytag repair man to come fix it.

With the old handle off, put the latch assembly against the actuator and press it on. This will simulate a closed door. Then take chanel locks and squeeze from sides and press new handle in ,large tabs first then lift up to snap small tabs in.