View single post by MultiplexMan
 Posted: Tue Sep 26th, 2006 02:48 am
Full Topic
MultiplexMan

 

Joined: Mon Sep 25th, 2006
Location: Sydney, Australia
Posts: 5
Status: 
Offline
Scuba - many thanks from Down Under for your post.

I found I did not have to drill any holes when replacing the drum rollers. 

I simply tilted the machine back upright, opened the door, and undid the four Torx screws that hold the white plastic trim around the dryer front opening. 

The front plastic trim and the plastic assembly where the drum rollers are mounted are one and the same.

This permits you to move the plastic trim inward.  Just enough to squeeze your hand in behind it to hold the load roller Nyloc nut. 

 

I have attached photos of the plastic trim dislodged with a view of the Nyloc nut.

Cheers and many thanks again:cheers:

Attachment: AskoT700_18 web.JPG (Downloaded 464 times)