Ron
| Joined: | Sun Apr 3rd, 2005 |
| Location: | |
| Posts: | 368 |
| Status: |
Offline
|
|
You can check the accuwash sensor. Your going to have to get to the control board. Remove the connector marked P5 from the board. Measure the resistance between P5-5 and P5-4 at the wire harness connector, it should read between 74K and 24K. If it's not in this range make sure there is continuity between the connector and sensor. If you have continuity here replace the temp sensor. If the valves and temp sensor check good, you have a control board issue...Ron
|
