 |
Full Topic |  |
| Joined: | Wed Aug 16th, 2006 |
| Location: | Michigan USA |
| Posts: | 1186 |
| Status: |
Offline
|
____________________
Tip Jar
| View single post by hvacdrd | ||||||||||
| Posted: Fri Sep 1st, 2006 06:06 pm |
|
|||||||||
hvacdrd
|
If it is noisy in spin and you are removing pieces of plastic it IS the bearing - you are in for a treat. First off try using a square head bit to remove the screws on the back panel and you will find it much easier. As you have read in this post you will likely need to replace the back half of the outer tub and may have a problem with the spin basket support arm as well, when you get it disassembled you will surely know.
____________________ Tip Jar |
|||||||||
|
| ||||||||||