View single post by kobayaashi
 Posted: Fri Aug 18th, 2006 02:22 am
PM Quote Reply Full Topic
kobayaashi

 

Joined: Thu Aug 17th, 2006
Location:  
Posts: 1
Status: 
Offline
Just replaced the latch handle on my dishwasher. Would never have been able to do it without the info on this thread.

It snapped on without chanel locks or too much force. With the latch assembly hooked to the actuator, I first put the small tabs in place, and then hooked one of the big tabs in it's hole. After this, the final big tab snapped into place with very little force. And to think it seemed that it would never fit just 20 minutes ago, before I found this forum.

Thanks to everyone who posted here!