| View single post by Mr. Ho | ||||||||||
| Posted: Mon Jun 26th, 2006 03:37 am |
|
|||||||||
Mr. Ho
|
I definitely have the same problem with my Maytag MSD2957AEW, and am thankful for all the good advice on this thread. I visually inspected the ADC board and found that the C2 was a bit bulged at one end. Based on what I've heard, seems like that's the culprit. Am ready to pony up the $55 or so to replace, but like everyone else, want to save a buck where I can. So... How involved is the process to solder a new C2 onto my existing ADC board? (I don't have the tools, etc, but am up for a challenge) Should I take the old C2 off first? Thanks...
|
|||||||||
|
| ||||||||||
