 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Thu Jun 15th, 2006 |
| Location: | |
| Posts: | 3 |
| Status: |
Offline
|
I had an unfortunate incident with a rug that crumbled to bits in the washer, thus clogging it completely, so now I am disassembling my GE WCXR1070T5WW in hopes of clearing the crud out of the bottom of the tub assembly.
I am unable to get the agitator pulled up and out of the spin basket. The service directions say "Remove agitator by grasping bottom and sharply pulling up" and I have done so in every way I can think of for about 2 weeks now. The agitator is not moving.
The directions (they are the originals from inside the front panel) have had one minor error already, where my washer has 2 screws to remove in the front, and the directions didn't list these screws, so I am wondering if this is the case again.
Any suggestions are much appreciated!
Attachment: agitator.jpg (Downloaded 103 times)