| View single post by Trying to help | ||||||||||
| Posted: Thu Jun 15th, 2006 01:54 pm |
|
|||||||||
Trying to help
|
Ohming out this motor is a little different. The old motor you could ohm individual windings, this one you must do two at a time so the resistance will be double. Ignoring the Green and I believe the two gray wires right next to each other, any combination of the remaining 3 should have approximately 6-7 ohms. Since they never published a schematic off the kit installed, I can guess off the wires on the new series above and go with Brown, White & Black. From Gray to Gray you should read 150-200 ohms.
____________________ If we saved YOU Beer $$ today, please make a donation to our beer fund by clicking the link below to help keep this site going. I charge $135.95 PLUS PARTS to do this repair!$! http://fixitnow.com/beerfund.htm |
|||||||||
|
| ||||||||||
