View single post by evofxdwg
 Posted: Thu Jun 15th, 2006 02:52 am
PM Quote Reply Full Topic
evofxdwg

 

Joined: Sat May 13th, 2006
Location:  
Posts: 10
Status: 
Offline
If you install the above kit, Also be sure and check this part for broken microswitch alignment pins (the thin projections in the rectangular holes on either side). If any of the round pins are broken, you will either have to replace it or glue them in place. And it is hard to align them properly. I hate to buy another badly designed part so i glued mine.

Attachment: another crappy part.jpg (Downloaded 117 times)