View single post by stumpowitz
 Posted: Wed Jun 14th, 2006 05:43 am
Full Topic
stumpowitz



Joined: Sun Jun 11th, 2006
Location: Dallas, Georgia USA
Posts: 320
Status: 
Offline
From the front remove the 5/16" screw with strain relief at the motor harness (the one attached to the motor) to remove the harness from motor to inspect. While this is out you can ohm the windings although I have yet to see this particular motor bad. If all checks good in all likelyhood you're looking at another motor control. If not installed too long ago, Devil's Disciple should have a guarantee on part. 



____________________
Please tell your friends about us! If we helped you we may be able to help them as well!