View single post by Ostrom
 Posted: Wed Jun 14th, 2006 04:33 am
Full Topic
Ostrom

 

Joined: Sat Jun 10th, 2006
Location: Carlisle, Massachusetts USA
Posts: 16
Status: 
Offline
 When I go into quick spin the door locks and the pump comes on.  After a few seconds (15?), the drum rotates slowly 3/4 of a turn and then stops.  It creeps forward another inch then stops.  Then the rotation sequence starts again.  It never seems to end.

I have 120vac (+/-) at black/white, and red/blue at the board and on both sides of the (filter capacitor?) little grey thing.  I have re-seated all the connections at the water valve, both pc boards, and at the motor itself.  I can't see the back side of the connector on the motor without pulling it.

Any further ideas?

Domo