View single post by Trying to help
 Posted: Mon Jun 12th, 2006 01:32 am
PM Quote Reply Full Topic
Trying to help

Joined: Fri Oct 21st, 2005
Location: Georgia USA
Posts: 2390
If you look at your connection on the thermistor on top of the water valve, does it appear to be corroded or discolored?? If so, it is what has caused your board to blow. If you put it in a cold fill and are not getting your L1 out of the board on the blue 37 wire to your cold water valve then the board is bad. Just check the connections on the thermistor so you don't blow up the next one as well.

Last edited on Mon Jun 12th, 2006 01:36 am by Trying to help

DIYers: Save time and money by learning the secrets of appliance repair... Click Here!