View single post by ktsenya2
 Posted: Sat May 21st, 2005 03:52 am
PM Quote Reply Full Topic
ktsenya2

 

Joined: Tue May 3rd, 2005
Location:  
Posts: 16
Status: 
Offline
Thanks Scott. The Door gasket was the initial item installed. You know how the seal takes a set after time and no longer seals effectively. Upon call back the was a very small drip, drip coming from the wiring bundle. OK so I open the liner and hey its dry inside there but the foam strip is wet along the lower edge but it is not saturated. Also It had taken a set too so change that out as well. Then to be sure replace the rotor. And still it leaks. In the past Ive done a lot of unusual things to get it to stop leaking including sucessive layers of duct tape to seal off the corners. I believe this is the weak spot in this design. Looking at them, I cant even imagine how they are holding back the flow.

Bob