View single post by Trying to help
 Posted: Fri May 19th, 2006 04:40 am
Full Topic
Trying to help



Joined: Fri Oct 21st, 2005
Location: Georgia USA
Posts: 2390
Status: 
Offline
Door is taken apart by the removal of the torx screws that surround the perimeter of the inside door panel. After the door is separated, you will see the orange wax motor that opens the soap cup. It is powered by the board. You have neutral sitting there at all times the door is closed and the board supplies L1 to it. On your schematic will be a test mode you can put the unit in to so you can do a voltage check to determine if the board is doing its job. The usual resistance of those wax motors is approximately 1500-2000 ohms. If it is reads open, it is bad. If it ohms good, it can still be bad and putting it into the auto test mode and checking the voltage will confirm.



____________________
If we saved YOU Beer $$ today, please make a donation to our beer fund by clicking the link below to help keep this site going. I charge $135.95 PLUS PARTS to do this repair!$! http://fixitnow.com/beerfund.htm