View single post by 70chevelless
 Posted: Fri Apr 28th, 2006 09:41 pm
PM Quote Reply Full Topic
70chevelless

 

Joined: Mon Sep 26th, 2005
Location:  
Posts: 10
Status: 
Offline
Kdog

 The door gasket is as hard as a rock on the bottom and about 1/4 of an inch up the sides?. About the space the house was built with a built in oven. I took the measurement's they are as follows. If your looking at the front of the oven I have 24inches on the left side 3inches on the right side and 4inches in the rear and 5inches on top. I don't know if this is enough but I would think it would be?. As far as putting in some kind of vent I'd rather just change the disk as Ive been looking at the price of the exhaust motor and piping then the door to the outside and it would be more than just to change the disc. I have a stupid question but what else is new! Why couldn't I just by another exhaust fan an original one like the one on top and put it down below to help circulate more air through the oven wire it to the top one so they both come on? Or I'll just have to order a few of them disc to keep on hand.