 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon Sep 26th, 2005 |
| Location: | |
| Posts: | 10 |
| Status: |
Offline
|
Yes your right when the unit fails you can still set it but it just stays on low with no heat in the oven. Also that is the part number I replaced this is the 4th one. You call it a disc?. I just put the new one in yesterday and it's working fine again. The bottom of the oven is not bent and we get good heat through the bottom and top vent. You say you put your to the left of the convection fan shaft when you say this I assume your looking at the back because ours is to the left of the shaft!. So then I take it this is just a design flaw nothing can be done about?