View single post by pdanger01
 Posted: Wed May 18th, 2005 03:11 am
PM Quote Reply Full Topic
pdanger01

 

Joined: Tue May 17th, 2005
Location:  
Posts: 3
Status: 
Offline
 Fisher and Paykel GWL10 washer stuck at rinse cycle.  Hasn't drained, fills for a couple of seconds then stops, begins filling, stops and so on.  I tried the diagnostics drain pump test (diagnostics mode, regular cycle button), and rather than draining, it fills water into the tub.  Currently have a tub full of sudsy clothes, looking for troubleshooting help.  Any help greatly appreciated.  Thanks.

 

I've spent a little more time troube shooting what I can.  I tested both water valves, and see that incoming water enters the tub at the back of the washer (lid hinge area).  I shut off both water valves to washer, tested to make sure no water flowed.  Then again tested drain pump, and that action pumps water into the tub, but from the right side.  Hope that narrows it down.  Again, any help greatly appreciated.

Last edited on Wed May 18th, 2005 04:19 am by pdanger01