| View single post by Trying to help | |||||||||||||
| Posted: Thu Apr 13th, 2006 03:45 am |
|
||||||||||||
Trying to help
|
With an empty tub, start the unit on wash, hot water. Look at the water volume going into the soap area. Let it run for 10 seconds to get a good look. Then, with the unit set for a cold rinse, move the timer to the #2 rinse and start it. Again monitor it for 10-20 seconds. Does the flow of water look the same? Is cold less? If it were a board, you would not be able to restart it. If you find a noticeable difference in pressures, clean out both the screens at the end of your inlet hose (where it hooks to house faucet) and your water valve.
____________________ If we saved YOU Beer $$ today, please make a donation to our beer fund by clicking the link below to help keep this site going. I charge $135.95 PLUS PARTS to do this repair!$! http://fixitnow.com/beerfund.htm |
||||||||||||
|
| |||||||||||||
