View single post by Dethedrus
 Posted: Sun Mar 26th, 2006 12:25 am
PM Quote Reply Full Topic
Dethedrus

 

Joined: Sat Mar 25th, 2006
Location:  
Posts: 5
Status: 
Offline
My Whirlpool Calypso washer (model #gvw9959kl2) is refusing to drain, and while doing a spin cycle will spin, but will not drain the water. It gives the code OB (off balance) 80% of the time and LD (long drain) the rest.

I removed the back panel, and can see that there's quite a lot of water in the tub (though just about none visible inside the washer itself), though I can't flip it on it's side to check for clogs or the like.

Any suggestions to at least drain so I can figure out if there's a specific clog or broken pump?