 |
Full Topic |  |
| Joined: | Tue May 3rd, 2005 |
| Location: | Wichita Falls, Texas USA |
| Posts: | 13120 |
| Status: |
Offline
|
Not sure if this is for your exact model, but sure describes your problem. Call Whirlpool tomorrow with your model and serial numbers and see if this is correct for your dishwasher. Pegi
THIS SERVICE POINTER APPLIES TO THE FOLLOWING BRANDS:
DISHWASHERS WITH ELECTRONIC
CONTROL
Models: KUD01, DU640XT, DUL300XT, GU1100XT, GU1200XT, GU1500XT, GU2300XT
Serial Code Range: FK28 – FM04
STOPS IN MID-CYCLE, INDICATOR LIGHTS BLINKING
Dishwasher will stop in mid-cycle and will not advance.
One or more of the cycle, option and status indicator lights
will blink.
K8178151
January 2002
CONDITION:
CAUSE:
RESOLUTION:
The electronic control is reacting to higher than normal
line voltage, (over 125 volts), and higher than normal line
signal distortion that exists in some parts of the country.
A revised electronic control, part #8530909, is available
to better handle high voltage conditions. The current stock
of replacement electronic controls has been reworked, to
supplement production controls being produced. Modified
controls will have a label, “REWORKED HI-LINE” to
identify them as reworked controls and are approved as
service replacements.
NOTE:
If the line voltage is normal and a single Cycle,Option or Rinse Only light is blinking, the cause is usually
a stuck or shorted keypad on the active overlay, not the
control. A resistance check of the active overlay should
always be made, using the keypad matrix in the product
tech sheet, prior to replacing the electronic control.
____________________
To ask a question, use our new forums==> http://appliantology.org
365-Day No-Hassle Return Policy at RepairClinic!
