 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Wed Feb 15th, 2006 |
| Location: | Georgia USA |
| Posts: | 104 |
| Status: |
Offline
|
Last edited on Tue Feb 28th, 2006 02:37 am by ratherbfishin
____________________
"ratherbfishin"
| View single post by ratherbfishin | |||||||||||||
| Posted: Tue Feb 28th, 2006 02:33 am |
|
||||||||||||
ratherbfishin
|
note ... you completely assemble lower half of washer including transmission pulley while upside down resting on outer tub, the tran pulley will drop thru opening in base. replace tub seal and bearing into outer tub,don't forget black rubber seal,looks like big rubber band. you should completely assemble bottom half of assembly, transmission, snubber(keep clean remove any grease,oils off snubber) ,brake rotor,brake stator and spring, screws go into lower transmission bearing, replace tub seal and bearing into outer tub then invert and place back into machine, replace tub springs and then replace hub and tub seal. Last edited on Tue Feb 28th, 2006 02:37 am by ratherbfishin ____________________ "ratherbfishin" |
||||||||||||
|
| |||||||||||||