View single post by RN
 Posted: Mon Feb 27th, 2006 02:44 am
PM Quote Reply Full Topic
RN

 

Joined: Tue Feb 21st, 2006
Location:  
Posts: 11
Status: 
Offline
Thanks for :pint:the information.  I used channel locks to get item 5 ("nut") off.  Bearing is bad.  It rattles and was most likely the source of the jet engine noise.  The spring did not seem that strong as the pressure is released by just backing out the screws.  ALready hand tub support off before I read you note on marking it.  Which way does the index hole for item 9 go in relation to cabinet?  Sure hope I don't have to do this every two years!!:violin:It is certainly a major operation.