View single post by applianceman18007260692
 Posted: Tue Jan 24th, 2006 04:55 am
Full Topic

Joined: Thu Nov 17th, 2005
Location: Mobile, Alabama USA
Posts: 1119
If the light wont burn then the power is shut down by the fuse, it located on the right side of the heater element housing, it is held by a clip that uses the same screw that holds the heater element,  take off the front panel and remove the lint ball thats built up in front of the blower and check the blower wheel itself for tightness to the motor shaft ,to access the heater housing you must use a thin blade to compress the spring clips that hold down the top, they are about 2 inches from each side of the dryer between the top and front. this is a common problem on this dryer

"May the hinges of our friendship never grow rusty"
-old Irish saying

Buy me a Beer: