View single post by atc guy
 Posted: Thu Jan 5th, 2006 12:14 am
PM Quote Reply Full Topic
atc guy

 

Joined: Wed Jan 4th, 2006
Location:  
Posts: 1
Status: 
Offline
Thanks for the  ASKO pdf, it was a lot simpler than the instructions from the parts store that they faxed to me. Also be sure to mark all of the wires you remove with masking tape as the schematic that comes with the machine is written in greek and unless you are sweedish  you probably won't get it.  I wrote them down on a piece of paper, but realized that there are too many same colors. I was able to use my notes and deduce from wire length as to where they should go, I was lucky.  The ASKO customer support was usless.  ATC GUY.