View single post by daveb
 Posted: Thu Dec 29th, 2005 05:04 pm
Full Topic
daveb

 

Joined: Thu Dec 22nd, 2005
Location:  
Posts: 14
Status: 
Offline
ok I admit I ASSume the motor is not getting voltage without having measured it assumption based only on the facts that the motor runs well in the agitate cycle, the door switch works, the drain hose is not clogged and the pump works. between what wires on the motor do I measure and read what voltage? An 8pin connector has 7 brown wires going into it and 6wires from the plug go down into the motor, a white wire feeds the brush on one side and a blue wire feeds the brush on the other side...