View single post by amstel
 Posted: Thu Dec 1st, 2005 09:39 pm
Full Topic
amstel

 

Joined: Thu Nov 17th, 2005
Location:  
Posts: 10
Status: 
Offline
Thanks for the reply. Just to clarify, although the pully seems very slightly bent (wobbles a little if set flat on the floor), my concern was more that the post the pulley bolts onto could be bent. The other concern was the slight movement (front to back) of the pully/drum assy once the pully is attached.

I will look into the weights further before sending this back. Could you explain what you mean by "the right hand" weight? There is the one that goes above the pully on the back and the large black covered one that goes all the way around the front. Do you know of any way these can be put on in an incorrect position that might cause it to be off balance?

I will probably not get to work on this anymore until Sunday. If you think of anything else by then, please pass it on!