View single post by amstel
 Posted: Wed Nov 30th, 2005 08:02 pm
Full Topic
amstel

 

Joined: Thu Nov 17th, 2005
Location:  
Posts: 10
Status: 
Offline
Well, I got the pulley on as tight as I can, but there is still a little play on the whole drum/pully assy. I closed it back up and ran it. It's still a bit too shaky during the fnial spin, even on "Normal" speed. It's nothing like it was when the spider on the old drum broke, but it's much louder and shakier than it was before the break.

The only thing I can think of is that there's somthing wrong with this new kit. Specifically, maybe the post the pulley attaches to is very slightly bent. I would imagine that could cause these symptons (fine during tumbles, shaky at high spin). I don't know how to check for this, though. Also, will aplliance clinic take it back and send me a new one if there's no glaring defect?