View single post by jfritz
 Posted: Sat Apr 30th, 2005 07:04 pm
PM Quote Reply Full Topic
jfritz

 

Joined: Fri Apr 29th, 2005
Location:  
Posts: 5
Status: 
Offline
ok,,

I replaced the rear bearing assembly of the dryer,

THe old one was definately tight  and a bit bound up ...

I put it back together,.. fired it up,, it ran ok.... then I put a small load of clothes in it

and it wouldnt start.. it tried,, moaned and groaned.. for about 5 seconds

and siezed

About 10 minutes later I tried to start it again and it fired up....

and currently running,,, but I dont think its going to last long...

I surely dont think it would even start under a full load.....

Any other Ideas ?