View single post by Pegi
 Posted: Fri Oct 14th, 2005 10:34 pm
PM Quote Reply Full Topic
Pegi



Joined: Tue May 3rd, 2005
Location: Wichita Falls, Texas USA
Posts: 13120
Status: 
Offline
Assuming there are no screws holding it, there are 2 shipping screws holding the two clips that hold the motor on, are these what you are seeing?  If the pump does not pull off we have had to smash them off with sharp tools and big hammer.   It is leaking anyway, do not see why you would not want to change it?  If you cannot get the pump off or of the motor shaft is too damaged to install a new pump you will be replacing the pump and motor both.  If you want to leave the leaking pump on the washer just remove the pump and motor together as one unit to get to the coupler.



____________________