View single post by jgpa
 Posted: Sun Nov 21st, 2010 08:06 pm
PM Quote Reply Full Topic
jgpa

 

Joined: Sat Apr 24th, 2010
Location:  
Posts: 5
Status: 
Offline
 I've been looking for the sheet - I used to have it but no more. I usually scan these things too and of course no copy.

Tub is empty, it appeared to have finished a cycle when this happened (tub was warm from heater). I've pulled the sequencer apart and it is all in working order. I moved the 'program' cam to where all the contacts are open and of course the aux pump isn't running now. I checked the circuit board and there are no obvious faults. In the process of cycling power I happened to get the sequencer drive motor to run but the normal light is still blinking. I can 't get the motor to run again however.

Does anyone know of any inputs the logic is looking for that could cause this behavior?

Thanks.