View single post by m98cox
 Posted: Wed Nov 17th, 2010 10:30 pm
PM Quote Reply Full Topic
m98cox



Joined: Tue May 16th, 2006
Location: Virginia USA
Posts: 7
Status: 
Offline
I have a Whirlpool WTW6400SW3. It begins the spin process, but, as it attempts to speed up, it stops and flashes "UL", unbalanced load.  It does this even though the washer is empty. The wash cycle works fine, and the slow spin is ok, its just when it tries to 'speed up' in its spin cycle.
Service guys aren't sure of the problem and say they've called Whirlpool and been told to replace the main board. However, they did saw that Whirlpool wasn't even sure.

Anyone else had this issue, or, does it make sense to be the board?